The answer to wood filler vs wood putty comes down to one question: has the wood been finished yet?
Wood filler goes on raw, unfinished wood, hardens, sands flush, and takes a finish like part of the board.
Wood putty goes on wood that is already stained and sealed. It stays soft forever and never gets sanded.
Most split and stacked firewood takes 6 to 12 months to season. Dense hardwoods like oak and hickory take 12 to 24 months.
But how long does it take to season firewood in your yard depends more on the month you split it than on the number of months you wait.
Wood glue is the stronger choice for wood-to-wood joints: furniture, edge glue-ups, joinery. Liquid Nails is the right pick for sticking wood to something that is not wood, or to a surface that is not flat.
Liquid nails vs wood glue is the comparison people get backwards most often. The tube that looks heavier duty is not the stronger one on a wood joint, and it is not close.
Buy the jigsaw first if your projects are shapes: signs, curves, cutouts.
It costs about $30 to $40 against $60 to $180 for an entry router, and it works the minute you unbox it.
Buy the router first if you are building furniture or cabinets and want clean joints and finished edges.
Teak oil works well on indoor and covered cedar. It deepens the color, pulls the grain forward, and stays where you put it.
On cedar that sits in full sun and rain, it is a weak choice. Most teak oil blends carry little real ultraviolet (UV) protection, so the cedar underneath keeps graying on schedule and you have signed up for a yearly recoat.
Southern Yellow Pine matches or beats Douglas fir on strength and soaks up preservative far better for outdoor work.
Eastern white pine and ponderosa are not close. So Douglas fir vs pine has no single winner until you know which pine sits in your store’s bin.
Framing nailer for anything that holds weight: studs, sheathing, decks, sheds, fences.
Brad nailer for anything thin and visible that is already glued: trim, molding, cabinet backs, small boxes.
These two do not overlap at any point.
No, shellac is not waterproof. It is water resistant, and the difference shows up the first time a sweating glass sits on it overnight.
A properly built film of three or four cured coats shrugs off spills and short contact without leaving a mark. Standing water is the problem, and it leaves a white haze in the film.
How to store firewood outside comes down to five decisions: get the stack 6 inches off the ground, keep it one or two rows deep with gaps between pieces, put it in the sunniest and windiest open spot you have, cover the top only, and leave the sides wide open.
Do that and the wood dries on schedule.
A 2×6 really is stronger and stiffer than a 2×4. Almost nobody picks one for that reason. 2×4 vs 2×6 gets decided by three other things: how much insulation the wall has to hold, whether pipes run through it, and how tall it stands.
Exterior walls in cold climates and any wall carrying a drain stack lean 2×6. Interior partitions, sheds, garages, workbenches, and shelving stay 2×4.